DEEP THIRST Inlet (3/8)

DRINK deeply with 3/8 tubing. -no restriction for your water/meth injection pump with this setup. Two feet (60cm) of translucent Teflon tubing and a pair of 90deg threaded fittings are supplied for easy visual diagnosis of feed status. With the pick up placed at the bottom of the tank, gravity primes the pump reliably for predictable service.

3/8" low-restriction water/meth inlet system w/push-connect fittings

USRT Guage Filtered Outlet Kit is also demonstrated in photos above/below.

water meth pump tank + inlet system for MK7 VW Jetta

DEEP THIRST water/meth 3/.8 inlet compared to 1/4 line

See the difference between 3/8" line and 1/4? Here is where pump flow potential is maximized. The 3/8 NPT threads require a drilled/tapped 3/8 NPT hole in a thick wall tank. -not thin wall (washer bottle, etc.) Our Race Tank and Street Tanks (shown above/below) are perfect solutions.

DEEP THIRST Inlet Kit + pressure gauge for water/meth

Note: This is the low/no-pressure side of the pump. These push-to-connect fittings are rated up to 290psi but will see 0psi here. (USRT can also supply a 6AN DEEP THIRST Inlet with black braided cloth.) Since attachment is via threaded connection, a thick wall tank is required (i.e. not a thin wall washer bottle or similar).

water methanol pump & tank + 3/8 inlet & pressure gauge outlet