RACE valve (4AN)

The RACE valve (4AN) offers unbeatable water/methanol injection CONTROL and most elegant integration options. Laser welded 4AN fittings and tiny size make packaging and integration simple. This part offers the highest performance in the entire industry. Unlike all other options on the market, RACE valves can be used optimally with many standard WMI controllers. They can be run at full 220psi pump pressure and at high cycle speeds with no limitations for usage time. Run them the rally way: HARD and ALL DAY.

USRT RACE valve (fast solenoid for water meth injection)

Normally, WMI pumps are pulsewidth modulated to match flow rates to engine load. They're big and powerful. -also relatively slow to respond to input commands. This method is quite adequate for basic air cooling. Real engine management, however, requires far more speed and precision. Fuel injectors are FAST but typically work at only 43.5 - 58psi on the gauge. They are way too weak to take water/meth pressure (and most will rust solid after mere hours of use).

RACE valves are corrosion-resistant and deliver EFI control precision at 220psi. -amazing!

USRT RACE valve water/meth for Mazda RX-7!

Technical parameters:

  • Official max pressure: 220 psi
  • Max flow rate: 600cc (at any pressure)
  • Material: SS304 alloy for durability with 100% water or 100% methanol (or any blend)
  • Thread type: 4AN
  • Position: normally closed
  • Length (tip to tip): 80mm (3.25")
  • Valve body diameter 15mm (0.60")
  • Wire leads: 16 gauge
  • Coil: 20.55W
  • Average current draw: 1.5A at 13.7V
  • Recommended Operating Frequency: 30 - 60Hz at 220psi
  • Unlimited duty cycle

USRT RACE valve after intercooler for air cooling

Special Notes:

RACE valves + water/meth distribution manifold

Crisp response requires short lines or direct connection to each nozzle holder. For multiple nozzle connections, USRT recomends small-diameter 3/16" (4.75mm) Teflon hose vs. the usual 1/4" Nylon hose (which is perfect for a main feed). This is very important. As is the number of valves used. One per cylinder is elite. The best balance of control vs. expense comes from a single valve per every two cylinders. However, one per three works adequately. (One per four cylinders typically results in a narrow but still very precise control range.)

AN fittings for water methanol injection (WMI)
Note: A full product line of custom 4AN water/meth fittings is now available to match USRT RACE valves.

$79.00

Add to Cart:

Ask a Question

  • Model: WAIRACE4AN
  • Manufactured by: US Rally Team

Customers who bought this product also purchased...


Contact USRT

  • +1(856)456-3335
  • Hainesport, NJ 08036
  • Email Us

Hours: Monday-Friday, 10-4 EST

Copyright © 2024 Usually Sideways Rally Team