Manufacturers

VR6 24V Oil Filter Housing

  • Model: OILHOUSEVR624
  • Manufactured by: Schimmel Performance

Starting at: $279.00

Please Choose:

Add Options









Add to Cart:

"Competition is none"; the Schimmel 24v Oil Filter Housing has no equal. Protect the whole investment under your hood with this investment for your block. The porting and machining artistry starts out with a 6.0lb billet block of 6061 T6 aluminum alloy. After many hours of machining, it is reduced to 2.25lb of perfected eye candy.

Equipped with the most common spin on oil filter thread, 13/16-16”, a builder may choose from over 20 different brands spin on filters including: Bosch, Amsoil, Mobil1, Fram, Wix, and high-end reusable examples, too.

The oil filter housing comes with one high-quality Mahle oil filter featuring an anti-drainback valve. This valve's purpose is to keep the oil filter filled at all times. So, when the engine is started, there will be an almost instantaneous supply of oil to the engine. Whereas, the original design allows oil to drain out of the filter through the oil pump when the engine is stopped. Upon next start up, oil must refill the filter before full oil pressure and flow can reach the engine.

The housing also features an extra 1/8 NPT port to feed a turbo with fresh oil or to install a proper oil pressure sender after the oil filter. The OEM oil filter housing has three ports for sensors on top. All of these ports are unfiltered oil from pan and are before the filter. Thus, any of these ports are subject to sending dirty oil to your turbo bearings which will drastically reduce its life and performance. And, in case of gauge setup, the pressure drop after the filter will not be factored in.

This = "DOING IT RIGHT".


Notes: Fits all 24v VR6 variants, rotating the Mocal thermoplate allows ports to be aligned as needed, mount is ideal  for 24v swap into MK1, MK2, MK3 when front engine bracket provisions are needed.

Each oil filter housing comes equipped as follows:
1. Oil Filter Housing
2. Cap screw fasteners
3. Mahle spin-on filter
4. OEM housing to block o-ring seals.


Copyright © 2019 Usually Sideways Rally Team. Powered by Zen Cart