Manufacturers

Race Geometry

MK2/3/Corrado Spherical Ball Joint kit

MK2/3/Corrado Spherical Ball Joint kit

Lower too far and roll center geometry is compromised.  Then, front end grip suffers and your Corrado G60, Mk2, or Mk3 (w/4x100 wheels)...
$299.00
... more info
MK2/3/G60 Bump Steer Elimination kit

MK2/3/G60 Bump Steer Elimination kit

Fits all A2 and A3 chassis using 4x100 spindle and hubs. This means standard Mk2 Golf/Jetta, Corrado G60, and early Mk3 4-cylinder...
$245.00
... more info
Tubular Front Cross Bar (MK2 & Corrado)

Tubular Front Cross Bar (MK2 & Corrado)

The Mk2 Front Tubular Cross Bar directly replaces the factory Mk2 Golf/Jetta front crossmember and adds both stiffness and strength to the front end....
$389.00
... more info
MK2/3/Corrado Front Control Arm Bearing kit

MK2/3/Corrado Front Control Arm Bearing kit

Fits all A2 chassis (including Corrado G60 & SLC). Lead time: 1 week Simply put, these are the most precise and durable suspension bearings ever...
$375.00
Add:
MK2/Corrado Rear Beam Spherical Bearing kit

MK2/Corrado Rear Beam Spherical Bearing kit

Simply put, these are the most precise and durable suspension bearings ever made to improve the classic VW rear twist beam. Only the highest quality...
$259.00
... more info
Tubular Front Control Arms (MK2)

Tubular Front Control Arms (MK2)

For Golf/Jetta Mk2 (plus Corrado G60), these tubular control arms complement lightweight early cars with lowered mass, greater stiffness, and...
$385.00
... more info
Tubular Front Control Arms (MK3 VR6)

Tubular Front Control Arms (MK3 VR6)

Mk3/Corrado VR6 tubular control arms are lighter, stiffer, and able to move more freely than stock equipment. Designed to improve front tire grip,...
$525.00
... more info
Front Control Arm Bushing (Rear)

Front Control Arm Bushing (Rear)

Front Control Arm Rear Bushing (2) Increase your car's handling performance by getting rid of the soft rubber stock bushings. These Powerflex...
$69.00
Add:
Front Control Arm Rear Bearing (Street/Rally/Race )

Front Control Arm Rear Bearing (Street/Rally/Race )

Stock control arm bushings are soft and promote torque steer under heavy throttle. When turning, unwanted toe angles cause the chassis to wander...
$199.00
Add:
Rod End Seal set

Rod End Seal set

This kit consists of rubber boots and short sleeves. The boot fits on the rod end shank and the side sleeves protect the bolt or shaft passing...
$25.00
Add:
Copyright © 2019 Usually Sideways Rally Team. Powered by Zen Cart