Manufacturers

Racing Geometry

MK1 4-Point Lower Stress Bar

MK1 4-Point Lower Stress Bar

For the money, a lower front stress bars is the most cost-effective way to improve A1 chassis vehicles. (That is, Rabbit/Golf, Jetta, Scirocco,...
$120.00
... more info
 Sold Out 
Tubular Front Control Arms (MK1 POLY)

Tubular Front Control Arms (MK1 POLY)

Poly-equpped Mk1 Tubular Control Arms are completely bolt in and are a direct replacement for factory bits.  Polyurethane bushings are firmer...
$420.00
... more info
 Sold Out 
Tubular Front Control Arms (MK1 HEIM)

Tubular Front Control Arms (MK1 HEIM)

Our Mk1 Tubular Control Arms are designed to significantly improve front tire grip, steering feedback and response, and handling at the limits...
$470.00
... more info
MK1 Spherical Ball Joint kit (roll center correction)

MK1 Spherical Ball Joint kit (roll center correction)

Fits all A1 Chassis including Scirocco II. Larger wheel diameter allows for a longer ball joint pin and thus more control arm leveling/roll center...
$299.00
... more info
MK1 Spherical Tie-rod Kit (bump steer elimination)

MK1 Spherical Tie-rod Kit (bump steer elimination)

This tie-rod kit resets the steering angle after lowering. Always combine with our Mk1 pherical Ball Joint kit which corrects roll center geometry....
$255.00
... more info
Tubular Front Cross Bar (MK1 Golf variants w/4-cylinder)

Tubular Front Cross Bar (MK1 Golf variants w/4-cylinder)

The Mk1 Tubular Front Cross Bar (for 4-cylinder engines) adds strength and stiffness to the ancient chassis's wiggly front end. Driving "feel" is...
$305.00
Add:
MK1 Rear Beam Spherical Bearing kit

MK1 Rear Beam Spherical Bearing kit

The rear of of our beloved Mk1 cars isn't exactly sophisticated. Lock it down and make it work by removing bushings wiggle and squish. After...
$245.00
Add:
MK1 Rear Toe Stabilizer kit

MK1 Rear Toe Stabilizer kit

Fits all A1 chassis including Scirocco II.
$465.00
Add:
MK1 FULL RACE Control Arms, Ball Joint, Bump Steer Combo

MK1 FULL RACE Control Arms, Ball Joint, Bump Steer Combo

Fits all A1 chassis including Scirocco II. Package includes drop pin ball joint setup. Customer must specify wheel size when ordering. Tubular Lower...
$1,500.00
... more info
Rod End Seal set

Rod End Seal set

This four-piece kit consists of rubber boots and short sleeves. The boot fits on the rod end shank and the side sleeves protect the bolt or shaft...
$25.00
Add:
Copyright © 2020 Usually Sideways Rally Team. Powered by Zen Cart