Cortex EBC is a high performance electronic boost and water/ methanol injection controller with virtually unmatched capabilities. Retain...
$299.00
... more info
The VC-50 features a boost referenced 2 1/16" (52mm) gauge progressive water-methanol controller. Heavily loaded, the VC-50 comes with a dual...
$240.00
Add:
This unit feature digital precision and settings display vs. the analog "two-knob" AEM WMI controller alternative. That's while the...
$149.00
Add:
This controller is unique in that it takes 0-5V inputs reads IDC from port fuel injected car's ECU (i.e. not direct injection). This means that...
$149.00
Add:
With just two simple knobs to adjust, the AEM unit is ideal for modestly equipped vehicles running up to 35 PSI of boost. An engine load referencing...
$149.00
Add:
Need a simple and dependable way to activate your direct port or pre-compressor water methanol injection system? Or, perhaps you'd like to turn...
$55.00
Add:
Allow or disallow flow at up to 370psi and establish air cooling only mode vs. cooling + octane. Or, use when a nozzle is mounted after a throttle...
$50.00
Add:
Finally! -a pressure gauge for adjusting water/meth pumps. Output pressure must typically be turned up or down to optimize flow rates. This is...
$45.00
Add:
Pressure sensors are the simplest and most reliable way to integrate failsafe protection. Capable of accurate measurements up to 400 PSI, they can be...
$59.00
Add:
Connect to the two wires behind your MK5+ OBD2 port to collect vehicle speed and RPM information. Late model vehicles use digital sensors. So,...
$90.00
Add: