Water/Meth Nozzle (25mm tip)

Nozzles optimization is about more than just flow rates. Length matters, too. These feature common 1/8 NPT on both ends. However, the bottom is extended 25mm. Flow rate is either 2gph or 4gph (~125cc or 250cc @100psi).

Standard nozzles are ideal for thin wall piping. However, it may take +10mm or even 25mm extension to poke through thick manifold runners. Reach around piping bends as needed.

The difference between shrouded spray pattern vs. "clean" is remarkable. Regular tuning complications, irregularities, and inconsistencies are dispensed with. Such cost precious time, money, and horsepower.

Notice the incredible control precision that 5x RACE valves provide. -the most advanced fast solenoids available for full 200psi water/methanol injection.

Thread on both top and bottom is 1/8 NPT for easy compatibility with popular water/methanol nozzle holders and manifolds. That includes the famous IE 1.8T intake manifolds and IE 2.0T intake manifolds which feature notoriously thick castings.