BIGGERupper (large turbo)

YOUR BIG TURBO DOESN'T FLOW ENOUGH AIR? It runs out of steam up top? We're going to fix that by making some. Hot air takes up more space than cold air. Inject water/methanol and the back pressure will instantly drop. The wastegate then forces the turbo to spin faster to raise it back to original setting. Any air restriction that the device imposes is more than offset by obvious flow gains.

The net result is greater mass air flow at the same final boost level. Spool characteristics are left identical to stock, but peak flow is "BIG UPPED". It's important to spray only as maximum boost is approached. So, this kit is best paired with a RACE valve. Or, go with a traditional Solenoid Upgrade plus a USRT Boost Trigga switch.

Spray is aimed directly at the center nut, the slowest moving and strongest section of the rotating assembly. Over tens of thousands of miles, the leading edges will likely attain a light polish.

Tip erosion is completely eliminated by positioning the spray point directly in front of the spinning wheel. (Whereas, a stand off installation leads to wall wetting, trickling, and constant impact on the blade tips. -the weakest and fastest-moving portion of the system.)

Note: A 1/4" compression fitting is supplied standard. If a 3/16" fitting is preferred, just ask and we'll substitute.
Note2: A spray nozzle is NOT supplied. -because we don't know which you'll need until you ask us for help about it. Do that. Contact us.
Note3: With a 3" coupler, the nozzle is well centered on the compressor nut. When installed in a 2.5" or 4" intake, it's positioned slightly off center and resembles what's depicted in the examples above.
Note4: This technology works especially well with heavy methanol concentrations due to it's extremely fast evaporation speed.